USB/Battery Wood Oval Base

Powering the Wood LED Base (with Batteries)

1. Open the battery compartment
   • Slide off the cover on the back of the wood base to access the battery slot.
2. Insert the batteries
   • Load 3 × AAA batteries (sometimes AA, depending on the specific model) into the battery bin with the correct polarity (+ / −).
   • Make sure batteries are fresh and oriented correctly.
3. Replace the battery cover
   • Snap the cover back on so batteries are secure.

Note: Some wood LED bases can also run from USB power instead of or in addition to batteries — if your unit has a USB port, you can connect it to a USB charger or power bank to power the lights.


🌈 Using the Touch Button Control
These wood bases typically have a single touch button on the top or side:
Turning On / Off

• Tap the button once → LED lights turn on.
• Double-tap the button quickly → LED lights turn off (some models use this for off).

Changing Light Colors / Modes

• Tap the button repeatedly → cycle through the RGB colors and light modes:
  • Red → Green → Blue → Orange → Purple → Cyan → White → Fading RGB mode.

Adjusting Brightness

• Long-press (≈4–5 seconds) on the button while lit → adjusts brightness up or down.

Loading the Acrylic Plate

1. Slide the panel into the slot on the wood base so the LEDs can illuminate it from below.

Care Tips

• Wipe the acrylic panel gently with a soft cloth — avoid abrasive cleaners.
• Don’t touch the acrylic surface with bare fingers once installed to keep it clear.

⚠️ Safety Notes

• This product is for indoor use only and is not waterproof.
• Always install batteries with correct polarity; remove exhausted batteries promptly.

 

Shop Oval Wood USB/Battery Signs